Malik Mcneill

• Welded in flat, horizontal, vertical, and overhead positions. 2g,3g,4g,5g, 4f,3f
• Bolted, clamped and tack-welded parts to secure components prior to welding.
• weld 40' and 20' i-beam stingers on the bottom of 24"x80' concrete piles
• cut and bevel beams to length and then fit steel beams with fabricated jig, dog and wedge flanges to get high low out and ran string lines to assure beam was square.
• align multi diameter pipe such as 24", 36". mark pipes with wrap around, cut square and bevel using torch or track torch, grind, use come alongs to pull pipes together, dog and wedge for high low, tack and weld.
• assist form work carpenters, adjust floor jacks for concrete floor forms, formwork, tie rebar, pour concrete, finish concrete
• run equipment like the forklift,manlift,excavator,bulldozer,skid steer

• drive h-piles for bridge abutment, drive 24" pipe piles for crane access work trestle.
• weld,cut,fabricate,repair
• remove and replace 3000' bridge over Wateree River

which consist of jack hammering and chipping out bridge deck. cutting and rigging steel girders. using oxylance to cut the steel

• rigging experience dealing with load calculation. proper rigging with shackles, endless nylon slings, steel slings and spreader bars
• flagging crane for small loads and critical picks
• promoted to leadman. lead crew in right direction to completing the job efficiently and safely.

• Drove piles for footers that allowed us to build columns to support heavy structures. 1-40 bridge winston salem project
• inspect pile hammer, inspect rigging, flag crane, communicate with co workers to complete the job efficiently and safely.
• drive piles, weld beams when needed, cut with oxy acetylene torch, fabricate and repair broken equipment.
• as leadman when the forman wasn't available i made sure the work got done and if there was any miscommunication or confusion we'd take 5 to regroup.

• Read blueprints and drawings to understand dimensions and design of form structure.
• Completed complex formwork projects requiring precise measurements and cuts, demonstrating attention to detail.
• Ensured compliance with safety regulations through regular inspection and maintenance of tools and equipment.
• Drive piles, Formwork,Tie Rebar,Pour and finish concrete, set girders for bridge.