Hunter Blanton

Run the laser machine.

Do trouble shooting on machine.

Put programs in the laser.

Clean trays out when needed.

Unload the metal after every cut.

Inspect metal for any defects or rust.

Pulled the fans from paint and assembled them.

Built the fans from start to end.

Basic fabrication when needed with the metal.

Drilled out holes when needed.

Inspect the fans for any defects.

Torque specs on bolts when needed.

Installed pillow blocks on fans, ran shaft through the blocks and aligned shaft to correct measurements.

Installed motor on fans and installed pulleys on motor shaft and pillow block shafts.

After pulleys were installed i put the belts on and lined pulleys up to correct measurements.

Fixed anything broken on my machines.

Daily PMS.

Changed cylinders, motors,counter weights,machine arms,shafts,pulleys, pillow blocks, flange bearings, roller bearings, belts, hydraulic pumps, chains, chain tensions, conveyor belts.

Rebuilt certain parts that needed it.

Changed bearings when needed.

Daily blade changed on machinery.

Some welding on parts that was needed.

Trouble shooting machinery.

Rebuild motors after i changed them out.